WORKHORSE CUSTOM CHASSIS: Safety Recalls in 2004

Updated on March 19, 2026.

There were 2 safety recalls made by WORKHORSE CUSTOM CHASSIS in 2004. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

April 22, 2004

(Campaign #: 50402-C)

WORKHORSE/FMVSS 101 AND 105/ INSTRUMENT CLUSTER

CERTAIN CHASSIS EQUIPPED WITH ACTIA CORPORATE INSTRUMENT CLUSTERS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NOS. 101 "CONTROLS AND DISPLAYS" AND 105 "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." IF THE BRAKE FAIL INPUT FALLS BELOW A VOLTAGE OF 1.5V, THE BRAKE FAILURE LAMP AND ALARM WILL BE ACTIVATED. ALSO ACTIVATION OF THE ABS TELL TALE WHEN THE ABS IS NOT PROPERLY FUNCTIONING DOES NOT ALWAYS OCCUR.

NHTSA ID: 04V195000

Component:

# of Units Affected: 30,345

Consequence Summary:

THIS DOES NOT MEET THE REQUIREMENTS OF THE STANDARD.

Corrective Action:

WORKHORSE WILL NOTIFY ITS CUSTOMERS AND REPROGRAM THE INSTRUMENT PANEL CLUSTER FREE OF CHARGE. THE RECALL BEGAN JANUARY 2005. OWNERS SHOULD CONTACT WORKHORSE AT 1-877-246-7731.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

February 18, 2004

(Campaign #: 50401-C)

WORKHORSE/BOSCH ZOPS BRAKE CALIPERS

ON CERTAIN MOTORHOME CHASSIS EQUIPPED WITH BOSCH ZOPS, THE PADS CAN DRAG ON THE ROTOR SURFACE DUE TO THE PIN SLIDE.

NHTSA ID: 04V084000

Component:

# of Units Affected: 10,235

Consequence Summary:

A HANG UP OR LOCK UP MAY CAUSE THE CALIPERS TO OVER HEAT AND NOT ALLOW THE DRIVER TO STOP SAFELY. THIS COULD CAUSE OVERHEATING OF THE BRAKE CALIPERS WHICH COULD RESULT IN A VEHICLE FIRE.

Corrective Action:

DEALERS WILL INSPECT, REPAIR AND REPLACE ACCORDING TO THE PROCEDURE DEVELOPED BY BOSCH (SEE CAMPAIGN 03E064000). THE RECALL BEGAN ON AUGUST 1, 2004. OWNERS SHOULD CONTACT WORKHORSE AT 1-877-294-6773.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details