WAYNE ENGINEERING CORPORATION: Safety Recalls in 1980

Updated on March 19, 2026.

There was 1 safety recall made by WAYNE ENGINEERING CORPORATION in 1980. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

June 6, 1980

(Campaign #: NR (Not Reported))

BRAKES:ELECTRIC:HYDRAULIC INTERFACE

IN THE PROCESS OF ASSEMBLY, WHICH INCLUDES TAPPING INTO THE CHASSIS STOP LIGHT SWITCH CIRCUIT, A BREAK OCCURRED IN THE CIRCUIT THAT PROVIDES CURRENT TO THE EMERGENCY BRAKING HYDRAULIC PUMP MOTOR. THIS CAUSES THE HYDRAULIC SERVICE BRAKE, HYDRAULIC POWER ASSIST BACK-UP SYSTEM TO BE INOPERATIVE WHEN THE IGNITION SWITCH IS IN THE "OFF" POSITION.

NHTSA ID: 80V071000

Component:

# of Units Affected: 147

Consequence Summary:

Corrective Action:

DEALER WILL CORRECT THE WIRING WITHOUT CHARGE.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details