WARD INDUSTRIES, INC.: Safety Recalls in 1980

Updated on March 19, 2026.

There were 2 safety recalls made by WARD INDUSTRIES, INC. in 1980. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

1977

1980

June 17, 1980

(Campaign #: NR (Not Reported))

LIGHTING:GENERAL OR UNKNOWN COMPONENT:BRAKE LIGHTS

VEHICLE DOES NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS". THE BRAKE WARNING LIGHT MAY NOT ACTIVATE WHEN THE IGNITION KEY IS ROTATED BETWEEN THE "ON" AND "START" CIRCUIT CHECKING POSITIONS.

NHTSA ID: 80V082000

Component: EXTERIOR LIGHTING

# of Units Affected: 115

Consequence Summary:

Corrective Action:

OWNER WILL RECEIVE INSTRUCTIONS TO INSPECT FOR PROPER GROUNDING OF THE IGNITION SWITCH AND TO CORRECT IT, IF NECESSARY.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

June 17, 1980

(Campaign #: NR (Not Reported))

EQUIPMENT:OTHER LABELS

VEHICLES MAY NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS". ON SOME VEHICLES THE TIRE AND RIM SIZE DESIGNATION AND THE COLD TIRE INFLATION PRESSURE WERE NOT FURNISHED.

NHTSA ID: 80V081000

Component: EQUIPMENT

# of Units Affected: 56

Consequence Summary:

Corrective Action:

DEALER WILL INSTALL A CORRECTED CERTIFICATION LABEL OVER THE EXISTING LABEL.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details