PAS, INC.: Safety Recalls in 1991

Updated on March 19, 2026.

There was 1 safety recall made by PAS, INC. in 1991. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

1991

1993

November 25, 1991

(Campaign #: NR (Not Reported))

BRAKES:HYDRAULIC:LINES:METALLIC

THE LINK CONNECTING THE ELECTRONIC REAR HEIGHT SENSOR TO THE REAR AXLE CAN DISCONNECT UNDER SEVERAL CONDITIONS, ALLOWING THE ARM ATTACHED TO THE SENSOR TO LODGE BETWEEN THE REAR AXLE ASSEMBLY AND THE RIGHT REAR BRAKE PIPE. THIS ABRADES THE BRAKE PIPE AND COULD LEAD TO REAR BRAKE FAILURE.

NHTSA ID: 91V207000

Component: SERVICE BRAKES, HYDRAULIC

# of Units Affected: 401

Consequence Summary:

ABRASION OF THE BRAKE LINE COULD RESULT IN LOSS OF REARBRAKES. THE FRONT BRAKES WOULD FUNCTION, BUT THE VEHICLE WOULD NEED INCREASEDSTOPPING DISTANCES WHICH COULD RESULT IN AN ACCIDENT.

Corrective Action:

INSTALL RETENTION CLIPS TO INSURE THE LOWER AND UPPER BALL SOCKET CANNOT BE REMOVED FROM THE BALL; ADD A DOWN STOP ON THE SENSOR ARM; AND ADD A SHIELD ON THE REAR AXLE.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details