Miller Electric Mfg. Co.: Safety Recalls in 2010

Updated on March 19, 2026.

There was 1 safety recall made by Miller Electric Mfg. Co. in 2010. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

2010

2022

October 29, 2010

(Campaign #: NR (Not Reported))

WHEEL ASSEMBLY

MILLER ELECTRIC IS RECALLING CERTAIN TRAILERS FOR IMPROPER HUB ASSEMBLY INSTALLATION. DURING THE ASSEMBLY SUPPLIER'S MANUFACTURING, THE ASSEMBLY BEARINGS MAY NOT HAVE BEEN PROPERLY TORQUE.

NHTSA ID: 10V541000

Component: WHEELS

# of Units Affected: 490

Consequence Summary:

AN IMPROPERLY TORQUED BEARING COULD CAUSE THE BEARING TO FAIL, RESULTING IN A FAILURE OF THE WHEEL ASSEMBLY AND A RISK OF A WHEEL FALLING OFF, DURING VEHICLE OPERATION, INCREASING THE RISK OF A CRASH.

Corrective Action:

MILLER ELECTRIC WILL INSPECT AND REPLACE THE HUB ASSEMBLY AND PROPERLY RE-INSTALL THE HUB ASSEMBLY FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN DURING NOVEMBER 2010. OWNERS MAY CONTACT MILLER ELECTRIC AT 920-734-9821.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details