MIDAS INTERNATIONAL CORP.: Safety Recalls in 1993

Updated on March 19, 2026.

There were 2 safety recalls made by MIDAS INTERNATIONAL CORP. in 1993. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

October 13, 1993

(Campaign #: NR (Not Reported))

BRAKES:HYDRAULIC:SHOE AND DRUM SYSTEM:DRUM

THE GROOVE FOR THE REAR WHEEL BEARING RETAINER RING WAS INCORRECTLY MACHINED.

NHTSA ID: 93E035000

Component: SERVICE BRAKES, HYDRAULIC

# of Units Affected: 300

Consequence Summary:

IF THE RETAINING RING DOES NOT SIT CORRECTLY IN THEGROOVE, THE AXLE LUG NUTS WILL BREAK, CAUSING THE BRAKE DRUM, WHEEL, AND TIREASSEMBLY TO SEPARATE FROM THE VEHICLE.

Corrective Action:

MIDAS SHOPS WILL REPLACE THE BRAKE DRUMS WITH OTHER BRAKE DRUMS FROM ANOTHER SUPPLIER.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

June 11, 1993

(Campaign #: NR (Not Reported))

EXHAUST SYSTEM:PIPE:EXHAUST

THE FLANGE OF THE EXHAUST PIPE HEAT SHIELD, LOCATED AT THE OUTLET END OF THE EXHAUST PIPE, CAN CONTACT THE VEHICLE OIL PAN. THE FLANGE CAN WEAR THROUGH THE OIL PAN CAUSING AN OIL LEAK.

NHTSA ID: 93E021000

Component: ENGINE AND ENGINE COOLING

# of Units Affected: 1,102

Consequence Summary:

IF AN OIL LEAK OCCURS, OIL CAN CONTACT THE HEAT SHIELDAND EXHAUST PIPE. MOTOR OIL CONTACTING HOT EXHAUST COMPONENTS COULD RESULT INA VEHICLE FIRE.

Corrective Action:

REPLACE THE DEFECTIVE EXHAUST PIPES WITH NON-DEFECTIVE PIPES.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details