Medtec Ambulance Corporation: Safety Recalls in 2011

Updated on March 19, 2026.

There was 1 safety recall made by Medtec Ambulance Corporation in 2011. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

February 14, 2011

(Campaign #: 11.03)

AMBULANCE ATTENDANT SEAT/FMVSS 207 & 210

MEDTEC IS RECALLING CERTAIN MODEL YEAR 2010 AMBULANCE TYPE II VANS FOR NOT COMPLYING WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEATING SYSTEMS," AND FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THE REAR FACING AMBULANCE ATTENDANT SEAT UTILIZES A STEEL FLOOR REINFORCEMENT PLATE ON THE BOTTOM SIDE OF THE ALUMINUM FLOOR SUBSTRUCTURE AND THE REINFORCEMENT PLATE WAS OMITTED IN SOME AMBULANCE BODIES.

NHTSA ID: 11V098000

Component:

# of Units Affected: 87

Consequence Summary:

IN THE EVENT OF A CRASH, THE SEAT BELT ASSEMBLY ANCHORAGE MAY DISCONNECT FROM THE FLOOR CAUSING THE ASSEMBLY TO FAIL TO RESTRAIN THE SEAT OCCUPANT INCREASING THE RISK OF INJURY TO THAT OCCUPANT.

Corrective Action:

DEALERS WILL INSTALL THE MISSING REINFORCEMENT PLATE UNDER THE FLOOR SUBSTRUCTURE FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING MARCH 2011. OWNERS MAY CONTACT MEDTEC TOLL-FREE AT 1-866-263-3832.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details