Irbit Motorworks of America, Inc.: Safety Recalls in 2007

Updated on March 31, 2026.

There were 2 safety recalls made by Irbit Motorworks of America, Inc. in 2007. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

August 22, 2007

(Campaign #: NR (Not Reported))

TRANSMISSION LOCK UP/HERZOG

ON CERTAIN MOTORCYCLES BUILT WITH A SIDECAR AND EQUIPPED WITH HERZOG TRANSMISSION GEAR SETS, THE TRANSMISSION MAIN SHAFT IS OUTSIDE OF ACCEPTABLE TOLERANCE DUE TO INCORRECT MANUFACTURING OF TRANSMISSION MAIN SHAFT AND SPECIFIC RETAINING CLIPS. THE MAIN SHAFT AND RETAINING CLIPS MAY BE DEFECTIVE.

NHTSA ID: 07V372000

Component: POWER TRAIN

# of Units Affected: 308

Consequence Summary:

TRANSMISSION DAMAGE, EXCESSIVE GEAR WEAR, HARD SHIFTING, AND POSSIBLE FAILURE CAN OCCUR RESULTING IN REAR WHEEL LOCK UP INCREASING THE RISK OF A CRASH.

Corrective Action:

THE MOTORCYCLES WILL BE INSPECTED AND IF THE TRANSMISSION HAS DEFECTIVE SHAFTS AND RETAINING CLIPS, THE COMPLETE TRANSMISSION WILL BE REPLACED FREE OF CHARGE. THE RECALL BEGAN ON JULY 24, 2007. OWNERS MAY CONTACT IRBIT AT 1-888-990-8484.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

March 8, 2007

(Campaign #: NR (Not Reported))

WHEEL BEARING REPLACEMENT

ON CERTAIN MOTORCYCLES, THE WHEEL BEARINGS MAY HAVE BEEN IMPROPERLY INSTALLED AT THE FACTORY.

NHTSA ID: 07V088000

Component: SUSPENSION

# of Units Affected: 33

Consequence Summary:

THIS CAN CAUSE LOOSE WHEELS OR WHEEL LOCK UP INCREASING THE RISK OF A CRASH.

Corrective Action:

DEALERS WILL INSPECT ALL WHEEL BEARINGS AND IF INSTALLED INCORRECTLY THEY WILL REPLACE THEM FREE OF CHARGE. THE RECALL BEGAN ON MARCH 9, 2007. OWNERS MAY CONTACT URAL AT 1-888-990-8484.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details