HOLIDAY RAMBLER CORP.: Safety Recalls in 1990

Updated on March 19, 2026.

There were 4 safety recalls made by HOLIDAY RAMBLER CORP. in 1990. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

November 20, 1990

(Campaign #: NR (Not Reported))

EQUIPMENT:OTHER PIECES

TURBULENCE CAUSED BY AERODYNAMIC QUALITES OF THE MOTORHOMES AT HIGHWAY SPEED CAN CAUSE THE AWNING TO UNROLL AND BREAK FREE FROM ITS MOUNTING SECUREMENT.

NHTSA ID: 90V195000

Component:

# of Units Affected: 134

Consequence Summary:

DETACHMENT OF AWNING WIHTOUT WARNING CREATES A BALLISTICOBJECT SHEARING FROM VEHICLE WHICH COULD CAUSE INJURY TO PERSON IN THE VICINITY.

Corrective Action:

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

October 19, 1990

(Campaign #: NR (Not Reported))

SUSPENSION:INDEPENDENT FRONT ATTACHING MECHANISMS:

THE SUSPENSION COIL SPRING BOX MOUNTING BRACKETS, WHICH ARE FASTENED TO THE MAIN CHASSIS FRAME, MAY FAIL.

NHTSA ID: 90V186000

Component: SUSPENSION

# of Units Affected: 336

Consequence Summary:

BRACKET FAILURE ALLOWS THE COIL SPRING BOX TO MOVE AND,CONSEQUENTLY, DAMAGE THE REAR BRAKE LINES AFFECTING BRAKE PERFORMANCE.

Corrective Action:

REPAIR TO PREVENT MOUNTING BRACKET FAILURE.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

August 27, 1990

(Campaign #: NR (Not Reported))

FUEL:FUEL LINES:HOSES:NON-METALLIC

INCORRECT SIZE EAR TYPE CLAMPS WERE USED TO SECURE NYLON GASOLINE LINES TO BARBED CONNECTOR FITTINGS.

NHTSA ID: 90V157000

Component: FUEL SYSTEM, GASOLINE

# of Units Affected: 154

Consequence Summary:

GASOLINE LINES UNDER PRESSURE FROM FUEL PUMP COULD LEAK;IN THE PRESENCE OF A SOURCE OF IGNITION, FUEL LEAK COULD RESULT IN A FIRE.

Corrective Action:

INSTALL PROPER SIZE EAR TYPE CLAMPS.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

March 12, 1990

(Campaign #: NR (Not Reported))

STEERING:WHEEL AND COLUMN

IMPROPER TORQUING OF STEERING WHEEL COULD CAUSE THE STEERING COLUMN STEEL SHAFT TO WEAR ON THE WHEEL ALUMINUM HUB.

NHTSA ID: 90V047000

Component: STEERING

# of Units Affected: 32

Consequence Summary:

THIS COULD EVENTUALLY ALLOW THE STEERING WHEEL TO BECOME DISENGAGED FROM THE SHAFT, WHICH COULD RESULT IN LOSS OF MOTORHOME CONTROL AND AN ACCIDENT.

Corrective Action:

REPLACE ALUMINUM HUB AND PROPERLY TORQUE THE STEERING WHEEL.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details