HENDRICKSON MFG. CO.: Safety Recalls in 1980

Updated on March 19, 2026.

There was 1 safety recall made by HENDRICKSON MFG. CO. in 1980. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

May 28, 1980

(Campaign #: NR (Not Reported))

SUSPENSION:SINGLE AXLE:REAR

THE BOLTS THAT CLAMP THE MOR/RYDE SUSPENSION BEAM AND LOWER MOUNTING PLATE TO THE AXLE MAY BREAK AS A RESULT OF MISALIGNMENT OF THE BOLTS DUE TO NON-PARALLEL SURFACES OF THE UPPER BEAM PLATE AND THE LOWER BOTTOM PLATE. ANOTHER CONTRIBUTING FACTOR IS THE ABSENCE OF SHEAR BLOCKS TO THE UPPER SPACER PAD.

NHTSA ID: 80V069000

Component: SUSPENSION

# of Units Affected: 75

Consequence Summary:

Corrective Action:

MANUFACTURER WILL INSTALL NEW MOR/RYDE BEAM ASSEMBLIES, LOWER MOUNTING PLATES, BOLTS, NUTS AND WASHERS.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details