DANA CORPORATION: Safety Recalls in 2008

Updated on March 19, 2026.

There was 1 safety recall made by DANA CORPORATION in 2008. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

January 7, 2008

(Campaign #: NR (Not Reported))

PINION GEARS BREAK

ON CERTAIN PINION GEARS, P/NOS. 129737 AND 127420, MANUFACTURED ON DECEMBER 4, 2007, AND ASSEMBLED INTO THE AXLE ASSEMBLY OF TANDEM-REAR OR SINGLE DRIVE AXLES INSTALLED AS ORIGINAL EQUIPMENT FOR CERTAIN INTERNATIONAL, PACCAR, AND VOLVO HEAVY TRUCKS, WRONG INDUCTION HARDNESS PROCESS SETTINGS WERE USED RESULTING IN EXCESSIVE HARDNESS OF THE PINION GEARS.

NHTSA ID: 08E003000

Component: POWER TRAIN

# of Units Affected: 68

Consequence Summary:

THE EXCESSIVE HARDNESS CAN POTENTIALLY RESULT IN THE THREADED END OF THE PINION BREAKING OFF. THIS FAILURE COULD RESULT IN DRIVESHAFT DISCONNECTING FROM THE AXLE, WHICH WOULD CAUSE LOSS OF VEHICLE POWER. IT IS ALSO POSSIBLE THAT THE DRIVESHAFT MAY SEPARATE FROM THE VEHICLE POSSIBLY RESULTING IN A VEHICLE CRASH.

Corrective Action:

DANA IS WORKING WITH THE VEHICLE MANUFACTURERS TO NOTIFY OWNERS AND HAVE THEIR VEHICLES REPAIRED FREE OF CHARGE. OWNERS SHOULD CONTACT THEIR VEHICLE MANUFACTURER FOR MORE INFORMATION.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details