DANA CORPORATION: Safety Recalls in 1994

Updated on March 19, 2026.

There were 2 safety recalls made by DANA CORPORATION in 1994. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

September 23, 1994

(Campaign #: NR (Not Reported))

SUSPENSION:SINGLE AXLE:REAR

THE AXLE SHAFTS HAD IMPROPER HEAT TREATMENTS AND CAN BREAK DURING OPERATION.

NHTSA ID: 94E030000

Component: SUSPENSION

# of Units Affected: 120

Consequence Summary:

BROKEN REAR AXLE SHAFTS CAN CAUSE THE REAR WHEELS TOSEPARATE FROM THE VEHICLE, RESULTING IN AN ACCIDENT.

Corrective Action:

THE REAR AXLE SHAFTS WILL BE REPLACED.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

June 2, 1994

(Campaign #: NR (Not Reported))

SUSPENSION:INDEPENDENT FRONT

THE OFFSET TOE ADJUSTING PIN CAN FRACTURE UNDER CONDITIONS SUCH AS TORSIONAL LOADS, FLEXING MOTION, IMPACT LOADS, AND OVERTORQUING.

NHTSA ID: 94E019000

Component: SUSPENSION

# of Units Affected: 919

Consequence Summary:

THIS CAN RESULT IN LOSS OF VEHICLE STEERING CONTROL ANDAN ACCIDENT.

Corrective Action:

DANA WILL PAY FOR REPLACEMENT AND LABOR COSTS OF THE ADJUSTMENT PIN WITHOUT CHARGE TO THE INSTALLING FACILITY AND THE VEHICLE OWNER. THESE PINS SHOULD BE REPLACED BY A FORD ORIGINAL EQUIPMENT PIN ASSEMBLY. OWNER OR INSTALLER INQUIRIES CONCERNING THIS RECALL CAMPAIGN SHOULD CONTACT DANA SERVICE CENTER AT 1-800-248-9606.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details