COBRA INDUSTRIES, INC.: Safety Recalls in 1993

Updated on March 19, 2026.

There were 2 safety recalls made by COBRA INDUSTRIES, INC. in 1993. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

June 7, 1993

(Campaign #: NR (Not Reported))

SUSPENSION:SINGLE AXLE:REAR:AIR SUSPENSION SYSTEM

THE LOWER BRACKET OF THE REAR SUSPENSION AIRBAG MAY BE MISLOCATED, AND MAY BE RUBBING AGAINST THE BRAKE LINE.

NHTSA ID: 93V099000

Component: SUSPENSION

# of Units Affected: 459

Consequence Summary:

RUBBING ON THE BRAKE LINE CAUSES WEAR AND COULD RESULTIN POSSIBLE BRAKE FAILURE AND AN ACCIDENT.

Corrective Action:

COBRA WILL INSPECT AND RELOCATE THE SUSPENSION AIR BAG BRACKETS AS NECESSARY.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

April 2, 1993

(Campaign #: NR (Not Reported))

EQUIPMENT:OTHER PIECES:TRAILER HITCHES AND ATTACHM

THE MOUNTING BRACKET FOR THE REAR TRAILER HITCH DOES NOT HAVE SUFFICIENT STRENGTH TO WITHSTAND THE LOADS OF AN ATTACHED TRAILER.

NHTSA ID: 93V054000

Component:

# of Units Affected: 24

Consequence Summary:

THE MOUNTING BRACKET CAN SEPARATE FROM THE MOTORHOME, ANDTHE TRAILER WILL ONLY BE ATTACHED BY THE SAFETY CHAINS, CAUSING POSSIBLE LOSSOF CONTROL OF THE TRAILER AND/OR THE MOTORHOME, WHICH COULD RESULT IN A VEHICLEACCIDENT.

Corrective Action:

INSTALL ADDITIONAL SUPPORT BRACKETS TO THE TRAILER HITCH FRAME.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details