Adient, PLC: Safety Recalls in 1992

Updated on March 19, 2026.

There were 2 safety recalls made by Adient, PLC in 1992. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

September 8, 1992

(Campaign #: NR (Not Reported))

ELECTRICAL SYSTEM:BATTERY

THE SEAL ON THE VENT CAPS OF THESE BATTERIES CAN BE BROKEN DUE TO A CRACK AT OR ABOVE THE SCREW IN THREAD. THE CRACK IS CAUSED BY USE OF AN INCORRECT MATERIAL IN THE PRODUCTION OF THE VENT CAPS.

NHTSA ID: 92E020000

Component: ELECTRICAL SYSTEM

# of Units Affected: 19,441

Consequence Summary:

THE VENT CAPS CAN EVENTUALLY SEPARATE FROM THE BATTERY,AND THE BROKEN SEAL CAN RESULT IN LEAKAGE OF HYDROGEN GAS INTO THE ENGINECOMPARTMENT, WHICH CAN CAUSE AN EXPLOSION.

Corrective Action:

REPLACE THE DEFECTIVE BATTERIES.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

August 12, 1992

(Campaign #: NR (Not Reported))

ELECTRICAL SYSTEM:BATTERY

THE MANIFOLD HOLES OF THE BATTERIES WERE NOT PLUGGED AND COULD ALLOW HYDROGEN AND OXYGEN GAS TO ESCAPE IN AN UNCONTROLLED MANNER.

NHTSA ID: 92E016000

Component: ELECTRICAL SYSTEM

# of Units Affected: 9,318

Consequence Summary:

IF A SPARK OR FLAME IS IN CLOSE PROXIMITY, IT COULDRESULT IN AN EXPLOSION.

Corrective Action:

INSTALL MANIFOLD PLUGS IN THE BATTERIES.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details