Winnebago Industries, Inc.: Safety Recalls in 1995

Updated on March 19, 2026.

There were 2 safety recalls made by Winnebago Industries, Inc. in 1995. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

October 12, 1995

(Campaign #: NR (Not Reported))

ELECTRICAL SYSTEM:FUSE AND FUSE RECEPTICLE

A SOLDER BRIDGE ON THE PRINTED CIRCUIT BOARD WITHIN THE FUSE PANEL OF THE POWER CONVERTER PASSED UNDETECTED THROUGH A TEST FIXTURE AND BYPASSES THE FUSE PROTECTING THE CIRCUIT.

NHTSA ID: 95E016005

Component: ELECTRICAL SYSTEM

# of Units Affected: 7,796

Consequence Summary:

THIS SOLDER BRIDGE, WHEN COUPLED WITH A DEAD SHORTELSEWHERE IN THE SYSTEM, CAN RESULT IN CIRCUIT OVERLOAD, OVERHEATING, ANDEVEN FIRE, WITHOUT WARNING.

Corrective Action:

DETAILED TEST INSTRUCTIONS ARE BEING PROVIDED. IF A DEFECTIVE FUSE PANEL IS FOUND, A NEW REPLACEMENT PANEL WILL BE INSTALLED.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

June 12, 1995

(Campaign #: NR (Not Reported))

ELECTRICAL SYSTEM:WIRING:OTHER PART

THE WIRES OF A 12-VOLT SOLENOID LOCATED INSIDE THE SIDE PLATE BEHIND THE DRIVER'S SEAT CAN SHORT ON THE SOLENOID CASE.

NHTSA ID: 95V117000

Component: ELECTRICAL SYSTEM

# of Units Affected: 82

Consequence Summary:

THIS CONDITION COULD RESULT IN A VEHICLE FIRE.

Corrective Action:

DEALERS WILL REMOVE THE SOLENOID AND REWIRE THE SWITCHING SYSTEM USING AN EXISTING INTERNAL RELAY.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details