Winnebago Industries, Inc.: Safety Recalls in 1987

Updated on March 19, 2026.

There were 2 safety recalls made by Winnebago Industries, Inc. in 1987. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

October 1, 1987

(Campaign #: NR (Not Reported))

FUEL:FUEL TANK ASSEMBLY:TANK

VEHICLES ARE SUBJECT TO EXCESSIVE UNDERBODY TEMPERATURES AND FUEL SYSTEM PRESSURES.

NHTSA ID: 87V155000

Component: FUEL SYSTEM, GASOLINE

# of Units Affected: 9,041

Consequence Summary:

THIS CREATES POTENTIAL FOR FUEL EXPULSION FROM THE FUELFILLER PIPE WHICH, IN THE PRESENCE OF AN IGNITION SOURCE, COULD RESULT IN AFIRE.

Corrective Action:

INSTALL AN ADDITIONAL VENTING SYSTEM TO MAIN FUEL TANK TO VENT THE SUPPLEMENTAL PRESSURE.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

October 1, 1987

(Campaign #: NR (Not Reported))

ELECTRICAL SYSTEM:WIRING:HARNESS:REAR COMPARTMENT

CERTAIN COMPONENTS WERE INCORRECTLY ASSEMBLED; SUCH AS THE HEAT RESISTANT COVER ON THE WIRING HARNESS, LOCATED ABOVE THE EXHAUST SYSTEM AND THE MUFFLERS REAR HEAT SHIELD AND REAR HANGER.

NHTSA ID: 87V156000

Component: ELECTRICAL SYSTEM

# of Units Affected: 802

Consequence Summary:

A FIRE CAN DEVELOP UNDER MOTORHOME FLOOR WHEN ENGINE ISWORKING HARD IN WARM TEMPERATURES.

Corrective Action:

REPLACE COVERING, ADD A HEAT SHIELD, AND REPOSITION MUFFLER HANGER.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details