TRACKER MARINE L.P.: Safety Recalls in 1994

Updated on March 19, 2026.

There were 2 safety recalls made by TRACKER MARINE L.P. in 1994. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

October 21, 1994

(Campaign #: NR (Not Reported))

EQUIPMENT:OTHER PIECES:TRAILER HITCHES AND ATTACHM

THESE TRAILERS ARE EQUIPPED WITH A "SWING-AWAY" TONGUE THAT FOLDS INTO A 90 DEGREE ANGLE WHEN IN STORAGE. THE HOLES USED FOR THE FASTENERS ARE LARGER THAN NEEDED, CAUSING A LOADED TRAILER TO WEAVE UNSAFELY.

NHTSA ID: 94V205000

Component:

# of Units Affected: 68

Consequence Summary:

THE TRAILER SWAYING CAN CAUSE AN OPERATOR TO LOSE CONTROL RESULTING IN AN ACCIDENT.

Corrective Action:

THE PIVOT BOLT AND HITCH PIN FASTENER HOLES WILL BE ENLARGED TO ACCOMODATE A STEEL BUSHING, WELDED IN PLACE.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

April 25, 1994

(Campaign #: NR (Not Reported))

WHEELS:LUGS:NUTS:BOLTS

THESE TRAILERS ARE EQUIPPED WITH AXLE ASSEMBLIES USING HUBS THAT AFFIX THE TIRE/WHEEL ASSEMBLY TO THE HUB WITH THREADED STUDS AND LUG NUTS. THE LUG STUD BOLTS MAY HAVE CRYSTALLIZED AND MAY POP OR TWIST OFF WITH LITTLE RESISTANCE.

NHTSA ID: 94V081000

Component: WHEELS

# of Units Affected: 321

Consequence Summary:

THIS CONDITION CAN RESULT IN UNEXPECTED SEPARATION OF THE WHEEL FROM THE AXLE, AND RESULT IN A VEHICLE ACCIDENT.

Corrective Action:

DEALERS WILL REPLACE THE HUB AND DRUM ASSEMBLIES WITH NEW THREADED STUDS AND LUG NUTS.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details