Terex South Dakota, Inc.: Safety Recalls in 2018

Updated on March 19, 2026.

There were 3 safety recalls made by Terex South Dakota, Inc. in 2018. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

November 9, 2018

(Campaign #: SN669)

Guide Arms May Fall Due To Insufficient Welds

Terex South Dakota, Inc. (Terex) is recalling certain 2017-2018 Terex Digger Derrick vehicles. The guide bar that attaches the pole guide arms to the pole guide tilt bracket may have insufficient welds, possibly resulting in the guide arm falling while in use.

NHTSA ID: 18V794000

Component:

# of Units Affected: 1,275

Consequence Summary:

If the pole guide arm falls, it may strike any nearby personnel, increasing the risk of injury.

Corrective Action:

Terex will notify owners, and dealers will replace the affected guide bars, free of charge. The recall is expected to begin December 14, 2018. Owners may contact Terex at 1-605-882-4000. Terex's recall number for this recall is SN669.

Park Outside Advisory: No

Do not Drive Advisory: No

Completion Rate (%): 40.31

View Full Recall Details

August 7, 2018

(Campaign #: SN665)

Undersized Weld at Auger Coupler

Terex south Dakota, Inc. (Terex) is recalling certain 2015-2018 Terex C4000, C5000, C6000, and General digger derricks. The welds between the coupler and hex shaft may be undersized, causing them to fail and the auger to fall unexpectedly.

NHTSA ID: 18V520000

Component:

# of Units Affected: 101

Consequence Summary:

If the auger falls, it can increase the risk of injury to the user or bystanders.

Corrective Action:

Terex will notify owners, and dealers will either repair the weld or replace the affected component, free of charge. The recall began October 3, 2018. Owners may contact Terex customer service at 1-605-882-4000. Terex's number for this recall is SN665.

Park Outside Advisory: No

Do not Drive Advisory: No

Completion Rate (%): 26.73

View Full Recall Details

January 8, 2018

(Campaign #: SN663)

Platform may Move Unexpectedly

Terex South Dakota, Inc. (Terex) is recalling certain 2015-2017 XT Pro 56, and XT Pro 60 aerial devices. The platform control enable system may be adjusted incorrectly. If not assembled and adjusted properly it may allow the rotation to move slowly if the enable is not depressed.

NHTSA ID: 18V008000

Component:

# of Units Affected: 1,526

Consequence Summary:

If the rotation system moves without the enable being depressed, it can increase the risk of injury.

Corrective Action:

Terex will notify owners, and dealers will inspect the single stick controls, making sure that they are assembled correctly and adjusted properly, free of charge. The recall began on March 7, 2018. Owners may contact Terex customer service at 1-800-982-8975. Terex's number for this recall is SN663.

Park Outside Advisory: No

Do not Drive Advisory: No

Completion Rate (%): 49.15

View Full Recall Details