Terex South Dakota, Inc.: Safety Recalls in 2008
Updated on March 19, 2026.
There were 5 safety recalls made by Terex South Dakota, Inc. in 2008. See the details of the recalls below.
You can also see similar information for other manufacturers.
Data Source: NHTSA.
December 2, 2008
(Campaign #: CB583)
FRONT OR REAR MOUNTED BUMPER WINCHES
TEREX TELELECT IS RECALLING 60 30,000 LB BUMPER WINCHES INSTALLED BY TEREX TELELECT FROM JANUARY 2003 THROUGH OCTOBER 2008 IN CERTAIN UTILITY TRUCKS. THE WINCHES WERE INSTALLED TO FACILITATE WORKING ON ELECTRICAL SERVICES AND COMMUNICATION LINES BOTH ON AND OFF ROAD. THESE WINCHES MAY BE EQUIPPED WITH WIRE ROPES THAT CAN NOT WITHSTAND THE PULL FORCE OF THE BUMPER WINCH.
NHTSA ID: 08E068000
Component: EQUIPMENT
# of Units Affected: 60
Consequence Summary:
PULLING AT FULL FORCE ON THE BARE WINCH DRUM MAY RESULT IN FAILURE OF THE WINCH LINE AND COULD RESULT IN DEATH OR SERIOUS INJURY.
Corrective Action:
TEREX TELELECT WILL NOTIFY OWNERS AND REPLACE THE WIRE WINCH ROPE IF IT IS LESS THAN 5/8" DIAMETER FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 22, 2008. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-882-4000.
Park Outside Advisory: No
Do not Drive Advisory: No
September 12, 2008
(Campaign #: CB582)
SERVICE AERIAL DEVICES
TEREX TELELECT IS RECALLING 142 TLM SERIES AERIAL DEVICES BUILT FROM JANUARY 2000 THROUGH MARCH 2003. THE PIN RETAINING BOLTS THAT HOLDS PIVOT PINS OR CYLINDER ATTACHING PINS IN PLACE CAN BREAK DUE TO LACK OF LUBRICATION OF THE PIN.
NHTSA ID: 08E058000
Component:
# of Units Affected: 142
Consequence Summary:
FAILURE OF THE RETAINER BOLTS ALLOWS THE PIN TO MOVE OUT OF POSITION AND THE BOOM TO FALL, POSSIBLY RESULTING IN PERSONAL INJURY.
Corrective Action:
TEREX WILL NOTIFY OWNERS AND REPLACE THE PIN RETAINER FASTENERS FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 26, 2008. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-882-4000.
Park Outside Advisory: No
Do not Drive Advisory: No
July 1, 2008
(Campaign #: CB581)
SERVICE AERIAL DEVICES
TEREX TELELECT IS RECALLING 60 TCP40 SERIES AERIAL DEVICES BUILT IN 2007. THE BOLTS THAT ATTACH THE BOOM TIP BRACKET TO THE THIRD BOOM CAN LOOSEN AND BREAK.
NHTSA ID: 08E043000
Component:
# of Units Affected: 60
Consequence Summary:
IF THE FAILED FASTENERS ARE NOT REPAIRED OTHER COMPONENTS WILL EVENTUALLY BE DAMAGED AND MAY ALLOW THE PLATFORM TO ROTATE, POSSIBLY RESULTING IN PERSONAL INJURY.
Corrective Action:
TEREX WILL NOTIFY OWNERS AND PROVIDE A REMEDY FREE OF CHARGE. THE RECALL BEGAN ON JULY 16, 2008. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-882-4000.
Park Outside Advisory: No
Do not Drive Advisory: No
January 25, 2008
(Campaign #: CB578)
HYDRAULIC ROTARY SELECTOR VALVES
TEREX IS RECALLING 4,060 TC, TCX, XM, RM, RMX, OM, TM, HA, 6-SERIES, AND FC SERIES AERIAL DEVICES EQUIPPED WITH HYDRAULIC ROTARY SELECTOR VALVES, P/NOS 68698, 459713, 463130, 476618, AND 9118243, MANUFACTURED BETWEEN JANUARY 1996 AND JANUARY 1, 2008. THE VALVE IS USED ON CLOSED CENTER, HYDRAULIC SYSTEM, AERIAL DEVICES. FAILURE CAN OCCUR WHEN THE VEHICLE IS PARKED AND THE AERIAL DEVICE IS OPERATING. THE AERIAL DEVICES ARE INSTALLED ON TRUCKS TO TRANSPORT THE AERIAL DEVICE TO THE WORK SITE TO FACILITATE WORKING ON ELECTRICAL POWER LINES AND COMMUNICATION LINES.
NHTSA ID: 08E008000
Component:
# of Units Affected: 4,060
Consequence Summary:
FAILURE OF THE VALVE MAY CAUSE LOSS OF OIL, THE HANDLE BEING EXPELLED AT HIGH SPEED, AND THE MACHINE WILL BE INOPERABLE, WHICH MAY RESULT IN SERIOUS INJURY OR DEATH TO THE OPERATOR.
Corrective Action:
TEREX WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE HYDRAULIC ROTARY SELECT VALVE FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 7, 2008. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-882-4000.
Park Outside Advisory: No
Do not Drive Advisory: No
January 25, 2008
(Campaign #: CB579)
AERIAL DEVICES/CHECK VALVES
TEREX IS RECALLING 1,167 TC SERIES AERIAL DEVICES EQUIPPED WITH CHECK VALVE, P/N 443847, INSTALLED FROM SEPTEMBER 2001 UNTIL MARCH 2007. THE VALVE IS LOCATED ON THE LOWER BOOM LIFT CYLINDER. FAILURE CAN OCCUR ONLY WHEN THE VEHICLE IS PARKED AND THE AERIAL DEVICE IS IN OPERATION. THE CHECK VALVE IS USED IN RETIMING OF THE BOOM WHEN THE PLATFORM IS OUT OF LEVEL. THE FLOW THROUGH THE CHECK VALVE CAN CAUSE THE SNAP RING TO FAIL IF THE RETIMING FLOW IS ABNORMALLY HIGH. THE CHECK VALVE COMPONENTS WILL FLOW INTO THE LIFT CYLINDER IF THE SNAP RING FAILS.
NHTSA ID: 08E009000
Component:
# of Units Affected: 1,167
Consequence Summary:
DEBRIS MAY SCRATCH THE CYLINDER WALL OR GET INTO HOLDING VALVES AND CAUSE THE PLATFORM TO DRIFT DOWN SLOWLY, WHICH COULD POSSIBLY RESULT IN SERIOUS INJURY OR DEATH TO THE PLATFORM USER.
Corrective Action:
TEREX WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE CHECK VALVES FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 7, 2008. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-882-4000.
Park Outside Advisory: No
Do not Drive Advisory: No
Popular Topics:
Find us
Copyright © Beautify Data LLC. All Rights Reserved.