Terex South Dakota, Inc.: Safety Recalls in 2007

Updated on March 19, 2026.

There were 3 safety recalls made by Terex South Dakota, Inc. in 2007. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

September 3, 2007

(Campaign #: CB575)

AERIAL DEVICE FAILURE

CERTAIN TEREX AERIAL DEVICES, MODELS HR37/40, HRM AND HRX EQUIPPED WITH BASKET LIFTER OPTION USING BASKET SHAFT WELDMAT 465451 MANUFACTURED BETWEEN APRIL 15, 2003, AND JULY 24, 2007, CAN DEVELOPE CRACKS NEAR THE WELD IN THE SUPPORT TUBE TO THE MAIN UPRIGHT TUBE.

NHTSA ID: 07E068000

Component:

# of Units Affected: 172

Consequence Summary:

CONTINUED OPERATION WILL ALLOW THE MATERIAL TO FATIGUE AND FAIL RESULTING IN UNCONTROLLED PLATFORM MOVEMENT AND POSSIBLE EJECTION OF OCCUPANTS. SERIOUS INJURY OR DEATH COULD OCCUR.

Corrective Action:

TEREX WILL NOTIFY OWNERS AND REPAIR THE UNITS FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 20, 2007. OWNERS MAY CONTACT TEREX AT 1-605-882-4000.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

April 27, 2007

(Campaign #: CB 573)

AERIAL DEVICE FAILURE

CERTAIN TEREX AERIAL DEVICES P/NO. TC MANUFACTURED BETWEEN JULY 16, 1996, AND FEBRUARY 1, 2004, INSTALLED ON TRUCKS TO TRANSPORT THE AERIAL DEVICE TO THE WORK SITE. TC MODEL AERIAL UNITS, WITH THE END MOUNT PLATFORM, HAVE A LEVELING SPROCKET AT THE LOWER BOOM THAT CAN DEVELOP CRACKS IN THE ARM WHICH CONTROLS PLATFORM POSITION. WHERE THE LEVELING CYLINDER ATTACHES TO THE ARM, IT CAN CRACK NEAR THE COUNTER SUNK GREASE FITTING AND OVER TIME FATIGUE AND FAIL.

NHTSA ID: 07E028000

Component:

# of Units Affected: 446

Consequence Summary:

IF THE ARM FAILS, THE PLATFORM MOVEMENT IS NOT CONTROLLED AND MAY DUMP THE PLATFORM OCCUPANTS.

Corrective Action:

TEREX TELELECT WILL NOTIFY OWNERS AND REPAIR THE AERIAL UNITS FREE OF CHARGE. THE RECALL BEGAN ON JUNE 1, 2007. OWNERS CAN CONTACT TEREX AT 1-605-882-4000.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

January 4, 2007

(Campaign #: CB 572)

AERIAL DEVICE FAILURE/CHECK VALVES

CERTAIN TEREX TELELECT DIGGER DERRICKS AND AERIAL DEVICES EQUIPPED WITH CHECK VALVES WITH P/NOS ENGRAVED ON THE VALVE OF; 1904F, 1908F, 1910F, AND 1910R. THESE VALVES CAN FAIL WHICH CAN CAUSE THE PARTS TO MOVE THROUGH THE HYDRAULIC SYSTEM OR WILL ALLOW A VACUUM TO FORM IN HYDRAULIC LINES IF THE PUMP FLOW SHOULD STOP. THESE DEVICES ARE INSTALLED ON TRUCKS TO TRANSPORT THE AERIAL DEVICE OR DIGGER DERRICK TO THE WORK SITE TO FACILITATE WORKING ON ELECTRICAL POWER LINES AND COMMUNICATION LINES OR TO TRIM TREES.

NHTSA ID: 07E001000

Component:

# of Units Affected: 2,099

Consequence Summary:

FAILURE OF THE CHECK VALVE CAN RESULT IN UNEXPECTED BOOM PLATFORM MOVEMENT AFTER THE CONTROL LEVER IS RETURNED TO THE NEUTRAL POSITION, OR ALLOW VACUUM TO FORM IN HYDRAULIC LINES TO THE BOOM TIP AND COULD CAUSE POTENTIAL DIELECTRIC FAILURE, POSSIBLY RESULTING IN DEATH OR SERIOUS INJURY.

Corrective Action:

TEREX UTILITIES WILL NOTIFY OWNERS AND REPLACE THE CHECK VALVES FREE OF CHARGE. THE RECALL BEGAN ON MARCH 22, 2007. OWNERS MAY CONTACT TEREX UTILITIES SERVICE DEPARTMENT AT 1-605-882-4000.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details