Skyline Corporation: Safety Recalls in 1995

Updated on March 19, 2026.

There were 2 safety recalls made by Skyline Corporation in 1995. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

September 22, 1995

(Campaign #: NR (Not Reported))

FURNACE:RECREATIONAL VEHICLE

THE FURNACES WERE IMPROPERLY INSTALLED. A 1 1/4" MINIMUM OVERLAP BETWEEN THE CHAMBER EXHAUST TUBE AND THE VENT ASSEMBLY EXHAUST IS NEEDED FOR PROPER EXHAUST.

NHTSA ID: 95V181000

Component: EQUIPMENT

# of Units Affected: 100

Consequence Summary:

THIS CONDITION CAN LEAD TO CARBON MONOXIDE POISONING.

Corrective Action:

DEALERS WILL REPLACE THE FURNACE VENT ASSEMBLY.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

July 31, 1995

(Campaign #: NR (Not Reported))

ELECTRICAL SYSTEM:FUSE AND FUSE RECEPTICLE

A SOLDER BRIDGE ON THE PRINTED CIRCUIT BOARD WITHIN THE FUSE PANEL OF THE POWER CONVERTER PASSED UNDETECTED THROUGH A TEST FIXTURE AND BYPASSES THE FUSE PROTECTING THE CIRCUIT.

NHTSA ID: 95E016002

Component: ELECTRICAL SYSTEM

# of Units Affected: 12,945

Consequence Summary:

THIS SOLDER BRIDGE, WHEN COUPLED WITH A DEAD SHORT ELSE WHERE IN THE SYSTEM, CAN RESULT IN CIRCUIT OVERLOAD, OVERHEATING, AND EVEN FIRE, WITHOUT WARNING.

Corrective Action:

DETAILED TEST INSTRUCTIONS ARE BEING PROVIDED. IF A DEFECTIVE FUSE PANEL IS FOUND, A NEW REPLACEMENT PANEL WILL BE INSTALLED.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details