Skyline Corporation: Safety Recalls in 1981

Updated on March 19, 2026.

There were 2 safety recalls made by Skyline Corporation in 1981. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

March 19, 1981

(Campaign #: NR (Not Reported))

INTERIOR SYSTEMS:SEAT TRACKS AND ANCHORS

ON SOME MOTOR HOMES, THE DRIVER AND PASSENGER SEATS MAY NOT BE SECURED TO THE CHASSIS IN COMPLETE CONFORMITY TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEAT MOUNTING SYSTEMS", AND NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES". THIS IS DUE PRIMARILY TO THE OMISSION OF CERTAIN WASHERS OR THE USE OF WRONG SIZED WASHERS WHEN SEATS WERE RE-ATTACHED AFTER CARPET INSTALLATION.

NHTSA ID: 81V034000

Component:

# of Units Affected: 500

Consequence Summary:

Corrective Action:

VEHICLES WILL BE CHECKED FOR PROPER INSTALLATION OF SPECIFIED WASHERS. ANY MISSING OR INCORRECT WASHERS WILL BE RECTIFIED WITHOUT CHARGE TO OWNER.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

March 18, 1981

(Campaign #: NR (Not Reported))

SUSPENSION:SINGLE AXLE:REAR:NON-POWER AXLE:SPRING

ON CERTAIN VEHICLES, THE AXLES MAY HAVE BEEN INSTALLED BACKWARDS. IMPROPER INSTALLATION MAY IMPAIR EFFECTIVENESS OF THE TRAILER BRAKES OR MAY CAUSE A SPRING TO BREAK.

NHTSA ID: 81V033000

Component: SUSPENSION

# of Units Affected: 137

Consequence Summary:

Corrective Action:

VEHICLE WILL BE INSPECTED AND, IF NECESSARY, THE AXLES WILL BE PROPERLY INSTALLED.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details