ROUSH INDUSTRIES, INC.: Safety Recalls in 2011

Updated on March 19, 2026.

There were 2 safety recalls made by ROUSH INDUSTRIES, INC. in 2011. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

August 31, 2011

(Campaign #: NR (Not Reported))

AFTERMARKET ROUSH PROPANE CONVERSION KIT/FUEL LEAK

ROUSH IS RECALLING CERTAIN AFTERMARKET ROUSH CLEAN TECH LIQUID PROPANE AUTOGAS FUEL SYSTEM KITS USED FOR INSTALLATION ON THE FOLLOWING VEHICLES: MODEL YEAR 2007 AND 2008 FORD E-350 (DUEL REAR WHEEL), MY 2009-2011 FORD E- 150, E-250, AND E-350, AND MY 2009-2011 FORD E-450 CUTAWAYS. THE FUEL RAILS INCLUDED IN THE KITS CONTAIN IMPROPERLY SEATED INJECTOR RETENTION CLIPS. THIS COULD RESULT IN LEAKAGE OF PROPANE AUTOGAS. THE PART NUMBERS OF THE AFFECTED KITS ARE: P07C2-176KIT-AB, P10C2-RCOMMKIT-AB, P10C2-R150KIT-AA, P10C2-R150KIT-AC, P10C2-R350KIT-AC, P11C2-R150KIT-AA, P11C2-R150KIT-AB, P11C2-R350KIT-AA, P11C2-R350KIT-AB, P10-SO-RKIT-BA, PBC2-RKIT158-AB, PBC2-RKIT176-AB, AND PBC2-RKITMB-AC.

NHTSA ID: 11E033000

Component: FUEL SYSTEM, OTHER

# of Units Affected: 286

Consequence Summary:

A GAS LEAK IN THE PRESENCE OF AN IGNITION SOURCE CAN RESULT IN A FIRE.

Corrective Action:

ROUSH WILL NOTIFY OWNERS OF THE VEHICLES OF WHICH THE KITS WERE INSTALLED ON IN ORDER TO ARRANGE FOR FREE REPLACEMENT OF THE INJECTOR RETENTION CLIPS. THE SAFETY RECALL BEGAN ON SEPTEMBER 29, 2011. OWNERS MAY CONTACT ROUSH AT 1-800-59-ROUCH (1-800-597-6874.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

May 31, 2011

(Campaign #: NR (Not Reported))

AFTERMARKET ROUSH PROPANE CONVERSION KIT

ROUSH IS RECALLING CERTAIN AFTERMARKET ROUSH CLEAN TECH LIQUID PROPANE AUTOGAS FUEL SYSTEM KITS PRODUCED BETWEEN DECEMBER 17, 2010, AND MAY 6, 2011, USED FOR INSTALLATION ON FLEET VEHICLES MODEL YEAR 2009 THROUGH 2011 FORD E-SERIES VANS/WAGONS/SHUTTLES/CUTAWAY (150, 250 AND 350) WITH 5.4L ENGINES ("E-SERIES"), AND MY 2011 FORD E-450 CUTAWAYS. THE VALVES INSTALLED IN THE SERVICE PORT OF THE FUEL RAILS OF THE KIT WERE UNDER MINIMUM SPECIFICATION FOR THE DIAMETER. THIS LED TO INSUFFICIENT COMPRESSION OF THE O-RING, ALLOWING LEAKAGE OF PROPANE AUTOGAS. THE PART NUMBERS OF THE AFFECTED KITS ARE: P10C2-R150KIT-AA, P10C2-R150KIT-AC, P10C2-R350KIT-AC, P11C2-R150KIT-AA, P11C2-R150KIT-AB, P11C2-R350KIT-AA, P11C2-R350KIT-AB, P-10-SO-RKIT-BA, PBC2-RKIT158-AB, PBC2-RKIT176-AB, AND PBC2-RKITMB-AC.

NHTSA ID: 11E019000