Pierce Manufacturing: Safety Recalls in 1990

Updated on March 19, 2026.

There were 2 safety recalls made by Pierce Manufacturing in 1990. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

April 2, 1990

(Campaign #: NR (Not Reported))

STEERING:POWER:SHAFT SECTOR

THE UNIVERSAL JOINTS AT EACH END OF THE STEERING SHAFT ARE ATTACHED TO THE SHAFT WITH A KEY AND SET SCREW. THE SET SCREWS MAY LOOSEN AND ALLOW THE KEY TO FALL OUT OF PLACE.

NHTSA ID: 90V063000

Component: STEERING

# of Units Affected: 372

Consequence Summary:

IF THE KEY FALLS OUT, THE UNIVERSAL JOINT WOULD SPIN ON THE SHAFT, RESULTING IN LOSS OF STEERING AND A POSSIBLE CRASH.

Corrective Action:

MODIFY STEERING LINKAGE TO PREVENT SET SCREW FROM LOOSENING AND KEY FROM COMING OUT OF KEY WAY.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

January 18, 1990

(Campaign #: NR (Not Reported))

INTERIOR SYSTEMS:SEAT AND SHOULDER BELTS AND BELT

CABLE PORTION OF SAFETY BELT ASSEMBLY (FEMALE RECEPTACLE MOUNTED INBOARD ON LEFT HAND SIDE, DRIVER'S SIDE, IN CREW CAB JUMP AREA) HAS BEEN TWISTED.

NHTSA ID: 90V006000

Component:

# of Units Affected: 424

Consequence Summary:

TWISTING CABLE REDUCES ITS HOLDING CAPACITY AND SAFETY BOLT COULD FAIL IN A CRASH, INCREASING THE POTENTIAL FOR INJURY TO OCCUPANT.

Corrective Action:

REPLACE SAFETY BELT ASSEMBLY.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details