Oshkosh Corporation: Safety Recalls in 1993

Updated on March 19, 2026.

There were 2 safety recalls made by Oshkosh Corporation in 1993. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

August 30, 1993

(Campaign #: NR (Not Reported))

BRAKES:HYDRAULIC:MASTER CYLINDER

A GAP BETWEEN THE MASTER CYLINDER AND REMOTE BRAKE FLUID RESERVOIR ADAPTER IS CAUSED BY AN OUT-OF-SPECIFICATION CONDITION IN THE ADAPTER, RESULTING IN HYDRAULIC FLUID LOSS DURING BRAKE APPLICATION.

NHTSA ID: 93E029001

Component: SERVICE BRAKES, HYDRAULIC

# of Units Affected: 1,026

Consequence Summary:

BRAKE FLUID LOSS RESULTS IN LOSS OF PRESSURE, CAUSINGPARTIAL LOSS OF BRAKING ABILITY.

Corrective Action:

REPLACE THE OUT-OF-SPECIFICATION ADAPTERS.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

April 20, 1993

(Campaign #: NR (Not Reported))

STRUCTURE:FIFTH WHEEL ASSEMBLY

THE CROSSHEAD KING PIN FORGINGS OF THE UPPER COUPLING ASSEMBLY CAN CRACK, CHIP, OR BREAK OFF. THIS CAN CAUSE COUPLER SEPARATION.

NHTSA ID: 93V064000

Component: TRAILER HITCHES

# of Units Affected: 201

Consequence Summary:

COUPLER SEPARATION CAN RESULT IN THE PIGGY-BACK TRAILERSEPARATING FROM ITS TOWING VEHICLE AND/OR A RAIL CAR, RESULTING IN A POSSIBLEVEHICLE ACCIDENT.

Corrective Action:

REPLACE DEFECTIVE KING PINS. OSHKOSH WILL WARRANT THE ENTIRE UPPER COUPLING ASSEMBLY FOR TEN YEARS AFTER INSPECTION AND REPAIRS.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details