Mercedes-Benz USA, LLC: Safety Recalls in 1995

Updated on March 19, 2026.

There were 2 safety recalls made by Mercedes-Benz USA, LLC in 1995. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

March 16, 1995

(Campaign #: NR (Not Reported))

BRAKES:HYDRAULIC:ANTI-SKID SYSTEM

THE MISADJUSTMENT OF A MACHINE TOOL ALLOWED METAL PARTICLES TO REMAIN IN THE REAR AXLE ABS SPEED SENSOR MOUNTING HOLE. THE PARTICLES CAN COME LOOSE, ATTACH TO THE SENSOR ASSEMBLY, AND FALSELY INDICATE A WHEEL-LOCK CONDITION TO THE ABS CONTROL UNIT.

NHTSA ID: 95V047000

Component: SERVICE BRAKES, HYDRAULIC

# of Units Affected: 558

Consequence Summary:

THIS FALSE SIGNAL CAN CAUSE PREMATURE ABS FUNCTION AT THE REAR BRAKES WHICH COULD INCREASE STOPPING DISTANCES.

Corrective Action:

DEALERS WILL INSPECT THE SENSOR OPENING FOR METAL PARTICLES AND REMOVE AS REQUIRED.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

February 21, 1995

(Campaign #: NR (Not Reported))

ELECTRICAL SYSTEM:WIRING

THE FRONT PASSENGER METAL FOOT REST CAN, OVER TIME, ABRADE THROUGH THE WIRING HARNESS UNDER THE FOOT REST CAUSING THE WIRING HARNESS TO SHORT CIRCUIT.

NHTSA ID: 95V031000

Component: ELECTRICAL SYSTEM

# of Units Affected: 50,000

Consequence Summary:

A SHORT CIRCUIT CAN CAUSE THE WIRES TO OVERHEAT, STALL THE ENGINE, OR INADVERTENTLY DEPLOY AN AIRBAG, ANY OF THESE INCREASES THE POTENTIAL FOR A VEHICLE CRASH.

Corrective Action:

DEALERS WILL INSTALL ADDITIONAL WIRING HARNESS CABLE FASTENER TIES AND EDGE PROTECTIVE COVERING FOR SHARP EDGES OF THE METAL FOOT REST.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details