MACHINE TOOL & GEAR, INC.: Safety Recalls in 2011

Updated on March 19, 2026.

There was 1 safety recall made by MACHINE TOOL & GEAR, INC. in 2011. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

January 27, 2011

(Campaign #: NR (Not Reported))

REAR AXLE CROSS PIN FRACTURE

MT&G IS WORKING WITH GENERAL MOTORS TO RECALL CERTAIN REAR AXLE CROSS PINS, PART NUMBERS 25824249 AND ED69145, SOLD FOR USE AS SERVICE PARTS IN CERTAIN GENERAL MOTORS VEHICLES. THE REAR AXLE CROSS PINS WERE NOT PROPERLY HEAT TREATED AND COULD FRACTURE AND BECOME DISPLACED WITHIN THE REAR AXLE. SHOULD THE PIN SHIFT OUT OF POSITION, IT COULD CREATE AN INTERFERENCE CONDITION AND CAUSE THE REAR AXLE TO LOCK.

NHTSA ID: 11E004000

Component: POWER TRAIN

# of Units Affected: 154

Consequence Summary:

THE DRIVER MAY NOT BE ABLE TO MAINTAIN DIRECTIONAL CONTROL OF THE VEHICLE AND A CRASH COULD OCCUR WITHOUT WARNING.

Corrective Action:

GENERAL MOTORS' DEALERS WILL INSTALL A NEW REAR AXLE CROSS PIN FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN DURING JANUARY 2011. OWNERS MAY CONTACT CADILLAC AT 1-866-982-2339, CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463 AND AT THE OWNER CENTER AT WWW.GMOWNERCENTER.COM.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details