Isuzu Motors Limited: Safety Recalls in 1994

Updated on March 19, 2026.

There were 2 safety recalls made by Isuzu Motors Limited in 1994. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

July 19, 1994

(Campaign #: NR (Not Reported))

ENGINE:CAMSHAFT (8/82)

CONSTANT EXPANSION AND CONTRACTION OF THE CYLINDER HEAD CAUSES THE CAMSHAFT SEAL END PLUG CAN BECOME DISLODGED FROM THE CYLINDER HEAD. THIS ALLOWS OIL TO LEAK FROM THE CAMSHAFT.

NHTSA ID: 94V132000

Component: ENGINE AND ENGINE COOLING

# of Units Affected: 122,297

Consequence Summary:

THIS CAN CAUSE ENGINE DAMAGE AND POSSIBLE ENGINE FIRE FROM OIL LEAKING ONTO THE HOT EXHAUST SYSTEM.

Corrective Action:

DEALERS WILL INSTALL CAMSHAFT END SEAL PLUG RETAINER PLATES.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

May 3, 1994

(Campaign #: NR (Not Reported))

BRAKES:HYDRAULIC:LINES:HOSE:NON-METALLIC

ON SOME VEHICLES, THE SEALING SURFACES FOR A HYDRAULIC BRAKE HOSE ON A FRONT BRAKE CALIPER WERE COVERED BY PAINT RESIDUE. BRAKE FLUID GRADUALLY DISSOLVES THE PAINT, OPENING A SMALL PATH BETWEEN THE SEALING SURFACE AND THE GASKET ALLOWING BRAKE FLUID TO LEAK WHEN THE BRAKE IS APPLIED.

NHTSA ID: 94V085000

Component: SERVICE BRAKES, HYDRAULIC

# of Units Affected: 130

Consequence Summary:

THIS CAN RESULT IN INCREASED STOPPING DISTANCES AND A POSSIBLE VEHICLE ACCIDENT.

Corrective Action:

DEALERS WILL REMOVE PAINT FROM THE BRAKE CALIPER, REPLACE COPPER GASKETS AND BLEED THE FRONT BRAKES.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details