Iowa Mold Tooling Co., Inc.: Safety Recalls in 2014

Updated on March 19, 2026.

There was 1 safety recall made by Iowa Mold Tooling Co., Inc. in 2014. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

June 13, 2014

(Campaign #: NR (Not Reported))

PTO Pressure Switch Oil Leak may Result in Fire

Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to determine if it is from the range of defective switches and if required, remove the pressure switch assembly and put a plug in the port where the PTO switch had been installed. This switch was never being utilized. This will be done free of charge. The recall is expected to begin in mid-July 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.

NHTSA ID: 14V328000

Component:

# of Units Affected: 21

Consequence Summary:

The leaking oil may soak into the thermal blanket covering the exhaust, which when combined with heat from exhaust, may result in an increased risk of fire.

Corrective Action:

Iowa Mold Tooling Co., Inc. will notify owners, and dealers will install a new pressure switch kit that moves the switch away from the exhaust system, free of charge. The recall began on July 28, 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.

Park Outside Advisory: No

Do not Drive Advisory: No

Completion Rate (%): 57.14

View Full Recall Details