Gillig, LLC: Safety Recalls in 1981

Updated on March 19, 2026.

There were 2 safety recalls made by Gillig, LLC in 1981. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

February 5, 1981

(Campaign #: NR (Not Reported))

STRUCTURE:BODY

ON CERTAIN VEHICLES, THE JOINTS USED TO ATTACH A REAR SETTEE TRIM PANEL MAY NOT MEET THE 60 PERCENT JOINT STRENGTH REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 221, "SCHOOL BUS BODY JOINT STRENGHT".

NHTSA ID: 81V018000

Component: STRUCTURE

# of Units Affected: 474

Consequence Summary:

Corrective Action:

ADDITIONAL FASTENERS WILL BE ADDED AT THE NON-COMPLYING JOINTS TO ENSURE COMPLIANCE WITH THE APPLICABLE SAFETY STANDARD. THIS SERVICE WILL BE PERFORMED WITHOUT CHARGE.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

January 7, 1981

(Campaign #: NR (Not Reported))

EQUIPMENT:OTHER LABELS

TIRE PRESSURE AND RIM SIZE INFORMATION MAY HAVE BEEN OMITTED FROM THE VEHICLE TIRE INFORMATION PLATE THAT IS MOUNTED IN THE DRIVER"S COMPARTMENT.

NHTSA ID: 81V006000

Component: EQUIPMENT

# of Units Affected: 367

Consequence Summary:

Corrective Action:

CORRECTED INFORMATION PLATES WILL BE SUPPLIED BY MANUFACTURER WITHOUT COST TO OWNER.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details