Erwin Hymer Group North America, Inc.: Safety Recalls in 2006

Updated on March 19, 2026.

There were 2 safety recalls made by Erwin Hymer Group North America, Inc. in 2006. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

May 11, 2006

(Campaign #: NR (Not Reported))

DECAL ON STEERING WHEEL

ON CERTAIN MOTOR HOMES BUILT ON CHEVROLET CHASSIS AND EQUIPPED WITH A DECORATIVE DASH TRIM KIT, THE ADHESIVE BACKED SYNTHETIC TRIM IS ATTACHED TO THE DASH, ENGINE COVER, DOOR PANEL AND THE CHEVROLET "BOW TIE" DECAL IS ATTACHED TO THE STEERING WHEEL (DIRECTLY OVER THE EXISTING BOW TIE IMPRESSION). THIS DECAL COULD AFFECT THE DEPLOYMENT OF THE AIR BAG SAFETY RESTRAINT BUILT INTO THE STEERING WHEEL.

NHTSA ID: 06V160000

Component: EQUIPMENT

# of Units Affected: 736

Consequence Summary:

IN THE EVENT OF A VEHICLE CRASH IN WHICH THE DRIVER SIDE AIR BAG IS DEPLOYED, THE RESULTING FUNCTIONALITY OF THE AIR BAG IS UNCERTAIN, WHICH CAN INCREASE THE RISK OF INJURY TO VEHICLE OCCUPANTS.

Corrective Action:

OWNERS WILL BE INSTRUCTED TO REMOVE THE STEERING WHEEL DECAL. THE RECALL BEGAN ON MAY 30, 2006. OWNERS MAY CONTACT HOME AND PARK AT 1-800-663-0066.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

March 9, 2006

(Campaign #: NR (Not Reported))

REAR AXLE LIFT KIT

ON CERTAIN CLASS B MOTOR HOMES BUILT ON CHEVROLET CHASSIS, WHEN THE REAR AXLE LIFT KIT WAS INSTALLED, THE U-BOLT NUTS WERE NOT TIGHTENED PROPERLY.

NHTSA ID: 06V070000

Component: SUSPENSION

# of Units Affected: 51

Consequence Summary:

A LOOSE REAR AXLE CAN CREATE A SLUGGISH DRIVING FEELING, REAR BOUNCING AND LOUD BANGING NOISE, INCREASING THE RISK OF A CRASH.

Corrective Action:

DEALERS WILL INSPECT AND RETIGHTEN THE U-BOLTS FREEE OF CHARGE. THE RECALL BEGAN ON MARCH 30, 2006. OWNERS MAY CONTACT ROADTREK AT 888-762-3873.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details