Erwin Hymer Group North America, Inc.: Safety Recalls in 1998

Updated on March 19, 2026.

There were 2 safety recalls made by Erwin Hymer Group North America, Inc. in 1998. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

October 20, 1998

(Campaign #: NR (Not Reported))

HOME AND PARK/FUEL LINE

VEHICLE DESCRIPTION: CLASS 'B' MOTOR HOMES BUILT ON DODGE 1500, 2500 AND 3500 VAN CHASSIS. THE FUEL LINE FROM THE FUEL TANK TO THE ENGINE MAY NOT BE PROPERLY SECURED TO THE CHASSIS. THE FUEL LINE CAN CONTACT THE ENGINE EXHAUST MANIFOLD CREATING A FUEL LEAK.

NHTSA ID: 98V261000

Component: FUEL SYSTEM, GASOLINE

# of Units Affected: 404

Consequence Summary:

THIS CONDITION CAN CAUSE FUEL OR FUEL VAPOR LEAKING RESULTING IN A POTENTIAL FIRE HAZARD. ALSO THE ENGINE COULD STALL FROM LACK OF FUEL, RESULTING IN LOSS OF POWER BRAKING AND POWER STEERING CONTROL.

Corrective Action:

DEALERS WILL INSPECT THE FUEL LINE FOR HEAT EXPOSURE DAMAGE, REPLACE IF NECESSARY, AND INSTALL THE FUEL LINE INTO EXISTING PLASTIC CLAMPS. A NYLON CABLE TIE WILL BE ADDED TO SECURE THE FUEL LINE TO AN ADJACENT WIRING HARNESS.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

June 22, 1998

(Campaign #: NR (Not Reported))

HOME AND PARK/FUEL VENT

VEHICLE DESCRIPTION: CLASS 'B' MOTOR HOMES BUILT ON DODGE 1500, 2500 AND 3500 VAN CHASSIS. THE FUELVENT HOSE FROM THE FUEL TANK TO THE FUEL FILL ENTRY MAY NOT BE VAPOR TIGHT DUE TO OVER TIGHTENING OF THE GEAR CLAMP AT THE CONNECTION OF THE PLASTIC VENT TANK OUTAGE TO THE RUBBER VENT HOSE. THIS CAN RESULT IN FUEL OR FUEL VAPOR LEAKING.

NHTSA ID: 98V136000