Erwin Hymer Group North America, Inc.: Safety Recalls in 1993

Updated on March 19, 2026.

There was 1 safety recall made by Erwin Hymer Group North America, Inc. in 1993. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

March 2, 1993

(Campaign #: NR (Not Reported))

EQUIPMENT:OTHER PIECES:AUXILLIARY GENERATOR

THE GENERATOR EXHAUST PIPE, LOCATED AT THE REAR ROADSIDE OF THE VEHICLE, CAN EMIT HOT EXHAUST GASES FROM A DAMAGED, WORN, DEFECTIVE, OR IMPROPERLY INSTALLED EXHAUST PIPE, MELTING THE ADJACENT POLYETHYLENE STORAGE TRUNK.

NHTSA ID: 93V026000

Component: EQUIPMENT

# of Units Affected: 969

Consequence Summary:

THE DAMAGED STORAGE TRUNK ALLOWS GENERATOR AND/OR VEHICLEEXHAUST GASES TO ENTER THE VEHICLE, RESULTING IN A HAZARD TO VEHICLE OCCUPANTS.

Corrective Action:

REPLACE ANY DEFECTIVE GENERATOR EXHAUST PIPES, REPAIR HOLES IN THE POLYETHYLENE STORAGE TRUNK, AND INSTALL A HEAT SHIELD BETWEEN THE GENERATOR EXHAUST PIPE AND THE STORAGE TRUNK.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details