Chrysler (FCA US, LLC): Safety Recalls in 1981

THE UNDERHOOD WIRING HARNESS AND VENTILATING HOSE MAY HAVE BEEN MISROUTED DURING VEHICLE ASSEMBLY. MISROUTING MAY CAUSE CHAFING BETWEEN THE HARNESS AND VARIOUS OTHER COMPONENTS, RESULTING IN SHORT CIRCUITS AND MALFUNCTION OF ELECTRICAL ACCESSORIES. THE SWITCH WHICH ACTIVATES THE ENGINE OIL PRESSURE WARNING LIGHT MAY NOT FUNCTION. THE CRANKCASE VENTILATION HOSE MAY BE TOO CLOSE TO THE AIR INJECTION MANIFOLD TUBE AND COULD BE DAMAGED IF ENGINE OVERHEATS.

THE AUTOMATIC SPEED CONTROL SWITCH MAY STICK IN THE "RESUME" POSITION RESTRICTING RETURN MOVEMENT. THIS WILL NOT ALLOW THE NORMAL BRAKE PEDAL OPERATION TO DEACTIVATE THE SYSTEM.

DUE TO A DEFECT IN THE WIRING SYSTEM, DEALER-INSTALLED AIR CONDITIONING KITS MAY CAUSE THE ENGINE TO CONTINUE RUNNING WHEN THE IGNITION KEY IS TURNED TO THE "OFF" POSITION AND THE AIR CONDITIONER IS IN OPERATION.

THE STOP LAMP SWITCHES INSTALLED ON THE SUBJECT VEHICLES MAY HAVE INADEQUATE INTERNAL SWITCH CONTACT PRESSURE DUE TO AN INCORRECT FORMATION OF THE SWITCH CONTACT TERMINALS. THIS LACK OF SWITCH CONTACT CONTINUITY MAY RENDER THE (STOP) BRAKE WARNING LIGHTS INOPERATIVE.

THE ACTUATION CHAIN OF THE CRUISE COMMAND COULD CATCH ON THE THROTTLE LINKAGE. THIS CAN CAUSE THE THROTTLE TO REMAIN IN A PARTIALLY OPEN POSITION.

THE CRUISE COMMAND ACTUATION CHAIN MAY CATCH ON THE THROTTLE LINKAGE, CAUSING THE THROTTLE TO REMAIN IN A PARTIALLY OPEN POSITION.

ENGINE MAY LOSE POWER OR STALL DUE TO CARBURETOR FLOODING. THIS IS CAUSED BY A POOR ELECTRICAL GROUND ON THE CARBURETOR FUEL BOWL VENT SOLENOID. VEHICLES MAY ALSO HAVE DRIVEABILITY PROBLEMS WHILE THE ENGINE IS WARMING UP IN COLD WEATHER. THESE PROBLEMS INCLUDE ENGINE MISSING, SAGS, AND HESITATION. THIS IS CAUSED BY A STICKING CARBURETOR OXYGEN FEEDBACK SOLENOID.

BRAKE FLUID MAY CONTAIN AN EXCESSIVE AMOUNT OF WATER. THIS CAN CAUSE DEGRADATION OF BRAKING PERFORMANCE OR BRAKE FAILURE UNDER A VARIETY OF CIRCUMSTANCES.

THE FRONT AXLE HUB SPACER MAY HAVE BEEN OMITTED FROM THE FRONT HUB AND BEARING CARRIER ASSEMBLIES. THIS CONDITION COULD ALLOW EXCESSIVE FRONT WHEEL BEARING MOVEMENT RESULTING IN WHEEL BEARING DAMAGE.

CERTAIN VEHICLES EQUIPPED WITH OPTIONAL STEP TYPE REAR BUMPER AND A 22-GALLON STEEL FUEL TANK MAY NOT COMPLY WITH REAR IMPACT TEST REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY". IF THE VEHICLE IS INVOLVED IN A COLLISION, FUEL SPILLAGE COULD OCCUR.

THE TRANSMISSION THROTTLE CONTROL ROD SPRING MAY HAVE BEEN IMPROPERLY INSTALLED. THIS MAY CAUSE THE THROTTLE TO CLOSE MORE SLOWLY THAN NORMAL. VEHICLES MAY RETURN TO IDLE SLOWLY.

THE LEFT OR RIGHT FRONT SAFETY BELT ASSEMBLY MAY HAVE BEEN INSTALLED ON THE INCORRECT SIDE OF THE VEHICLE. THE SHOULDER BELT LOCKING MECHANISM MAY NOT FUNCTION UNDER RAPID DECELERATION. UNDER HARD BRAKING APPLICATIONS OR IN A COLLISION, THE SHOULDER PORTION OF THE SEAT BELT SYSTEM MAY FAIL TO PROPERLY RESTRAIN THE PASSENGER. THERE IS INCREASED RISK OF INJURY TO PASSENGERS WHO MAY CONTACT OTHER OBJECTS UNDER THESE CIRCUMSTANCES.