Chrysler (FCA US, LLC): Safety Recalls in 1980

SOME OF THE INVOLVED VEHICLES WERE ASSEMBLED WITH TONGUE-END REAR SEAT BELT ASSEMBLIES INSTEAD OF THE BUCKLE END AND TONGUE-END ASSEMBLIES. WITHOUT THE BUCKLE END ASSEMBLIES, THE REAR SEAT BELTS CANNOT BE FASTENED.

THE ENGINE COMPARTMENT FUEL LINE HOSES INSTALLED ON CERTAIN VEHICLES WERE FABRICATED FROM A DEFECTIVE RUBBER COMPOUND. WHEN SUBJECTED TO CONTINUOUS HIGH UNDERHOOD TEMPERATURES, THESE HOSES MAY BECOME BRITTLE AND CRACK.

THE HOOD SECONDARY LATCH ON THE INVOLVED VEHICLES MAY BE SUBJECT TO BINDING DUE TO VARIATIONS IN THE LATCH AND ITS MOUNTING BASE ASSEMBLY. A PROBLEM COULD OCCUR IF THE PRIMARY LATCH BECAME INOPERATIVE OR WAS NOT PROPERLY ENGAGED.

THE ALTERNATOR FIELD WIRING TERMINAL CONNECTIONS ON THE INVOLVED VEHICLES MAY LOOSEN DUE TO VIBRATION, POSSIBLY RESULTING IN AN OPEN CIRCUIT CONDITION. SHOULD THIS OCCUR, ALTERNATOR ELECTRICAL OUTPUT TO SUPPORT THE VEHICLES ELECTRICAL LOADS AND THE BATTERY CHARGING SYSTEM WOULD BE LOST. THIS WOULD EVENTUALLY RESULT IN OBVIOUS MALFUNCTIONS OF VARIOUS ELECTRICAL SYSTEMS (DIMMING OF LIGHTS, REDUCTION IN RADIO VOLUME, ETC.).

DUE TO A COMBINATION OF DISC BRAKE PAD WEAR AND TURN STOP WEAR ON CERTAIN VEHICLES, THERE MAY BE AN INCREASE IN BRAKE PEDAL TRAVEL AND A REDUCTION IN FRONT BRAKING EFFECTIVENESS FOLLOWING A FULL TURN. ALSO, A FRAME CRACK COULD DEVELOP AND COULD EXTEND THROUGH ALL OR MOST OF THE RAIL SECTION.

THE HINGE AND ROLLER ASSEMBLIES SUPPORTING THE REAR OF THE SLIDING SIDE DOOR MAY BE SUBJECT TO FAILURE AS A RESULT OF PROCESSING DEFICIENCIES IN THE ALUMINUM HINGE BODY.

VEHICLES MAY NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES AND ASSOCIATED EQUIPMENT". ON CERTAIN VEHICLES, THE FRONT PARK AND TURN SIGNAL LAMPS MAY CONTAIN INCORRECT LAMP BULB SOCKET ASSEMBLIES. ENGINEERING TESTING DETERMINED THAT THESE LAMPS DO NOT PRODUCE A SUFFICIENT AMOUNT OF LIGHT.

THE FEDERAL MOTOR VEHICLE SAFETY STANDARD CERTIFICATION LABELS ON THE INVOLVED VEHICLES MAY CONTAIN INCORRECT DATA FOR THE INCOMPLETE VEHICLE (CHASSIS) DATE OF MANUFACTURE AND FOR THE DATE OF FEDERAL MOTOR VEHICLE SAFETY STANDARD CONFORMANCE EFFECTIVENESS.

THE FRONT RAIL EXTENSION MAY EXPERIENCE FATIGUE CRACKING NEAR THE AREA WHERE THE POWER STEERING GEAR ATTACHES TO THE FRAME. IF THE CRACK PROGRESSES THROUGH MOST OR ALL OF THE RAIL SECTION, STEERING SYSTEM FREE PLAY ACCOMPANIED BY METALLIC RATTLE NOISE WILL BE EXPERIENCED.

THE RIGHT AND LEFT REAR WHEEL BEARINGS MAY HAVE BEEN DAMAGED DURING ASSEMBLY. A DAMAGED BEARING COULD RESULT IN AXLE AND WHEEL DISENGAGEMENT FROM THE VEHICLE WHILE IN MOTION.

THE ASHTRAY BULB SOCKET IN THE INVOLVED VEHICLES MAY HAVE BEEN MANUFACTURED WITH MATERIALS THAT DO NOT POSSESS THE REQUIRED ELECTRICAL RESISTANCE QUALITIES. WHEN THE ASHTRAY BULB IS LIT FOR AN EXTENDED PERIOD OF TIME, THE SOCKET IS SUBJECT TO OVERHEATING.