ARMSTRONG RUBBER CO.: Safety Recalls in 1980

Updated on March 19, 2026.

There were 2 safety recalls made by ARMSTRONG RUBBER CO. in 1980. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

October 7, 1980

(Campaign #: NR (Not Reported))

TIRES:CORD

TIRES MAY NOT COMPLY WITH STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 119, "NEW PNEUMATIC TIRES FOR VEHICLES OTHER THAN PASSENGER CARS". THE NON-COMPLIANCE IS ATTRIBUTED TO THE USE OF A FABRIC IN THE TOP PLY OF THE BODY WHICH WAS LOWER IN STRENGTH THAN SPECIFIED.

NHTSA ID: 80T019000

Component: TIRES

# of Units Affected: 73

Consequence Summary:

Corrective Action:

TIRES WILL BE REPLACED AT NO CHARGE WITHIN 60 DAYS OF OWNER NOTIFICATION.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details

October 2, 1980

(Campaign #: NR (Not Reported))

TIRES

TIRES DO NOT MEET THE ENDURANCE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 109, "NEW PNEUMATIC TIRES". UNDER ADVERSE CONDITIONS OF OVERLOAD, UNDERINFLATION OR EXCESSIVE SPEED, THESE TIRES ARE SUSCEPTIBLE TO PREMATURE FAILURE IN SERVICE.

NHTSA ID: 80T018000

Component: